Sunday, January 26, 2020

Jeep Specs

2010 JKUR 1J4BA6H19AL144419

Tires: 32" 255/75R17
(Will fit -- just barely -- 33x12.50)

Wheels: 17"
5x5" Lug Pattern

Fluids:
Transmission: NSG370 (built by Mercedes)
The NSG370 does not use standard gear oil for lubrication
MOPAR Manual Transmission Lubricant or equivalent (meeting the re- quirements of Chrysler Material Standard MS-9224).

3.8L Engine Oil..............6 Quarts / 5.7 Liters........5w-20
.............................Chrysler MS-6395; if not API-SN
Brake Fluid..................Fill to Full Mark............DOT 3
Power Steering Reservoir.....Fill to Full Mark............ATF 4
3.8L Cooling System..........13 Quarts....................50/50 HOAT Antifreeze/Water Mix
NSG370 6-Speed Manual........1.6 Quarts / 1.5 Liters......Mopar Manual Trans Lubricant or Equivalent
NV241 Transfer Case..........2.2 Quarts / 2 Liters........ATF4
Dana 44 Front Axle...........2.7 pints / 1.3 Liters.......80w90
Dana 44 Rear Axle............4.75 Pints / 2.25 Liters.....80w90/75w140 summer towing


Filters:
Oil: Wix 51348
Air: Wix 49018


Tools Needed:

NSG370 Fluid Change: 1" M10 Bolt with two nuts (used to remove drain plug); 17mm wrench, 14mm Allen socket

NV241 Fluid Change: 10mm Allen socket, 18mm socket (remove cross member in the way)

Oil Change: 13mm socket

Front Brake (Pads):
13mm socket 26ft-lbs
21mm socket 100ft-lbs
11mm, 15mm wrenchs
Front Wheel Sensor -- 5mm Hex

Teraflex HD HD Chromoly Tie Rod Kit
OEM SKU 1853910
OEM SKU Ball Joint: 1344410; spare ordered to put in Jeep.

Factory Front Drive shaft u-joint: Non-serviceable w/o modifying yoke; Adams on order :)

Carbon Offroad Jeep JK Rubicon 2007-2018 4340 Chromoly Front Axle Kit Dana 44 CF155
1350 Series Spicer 5-7166X U-Joint; spare ordered to put in Jeep.

Front Axle Seal (verified by VIN online) Mopar p/n 5014852AB
Cross Reference:
Mopar 5014852AC
SKF 12579A
Spicer 54381
Timken / National 710863


Winch: Warn 10-S

Antirock Sway Bar:
Nuts are 1/2" (3/4" socket); uncertain if one side is RH and other LH thread.





Not JK specific; generic parts of a clutch:


Stock height specs (not sure if this is different for Rubicon):


Torque Specs:
Generic Torque Chart:

Bolt Diameter Standard Metric
1/8" 5/16" 8mm
3/16" 3/8" 10mm
1/4" 7/16" 11mm
5/16" 1/2" 13mm
3/8" 9/16" 14mm
7/16" 5/8" 16mm
1/2" 3/4" 19mm
9/16" 13/16" 21mm
7/8" 22mm
5/8" 15/16" 24mm
1" 25mm
3/4" 1-1/8" 29mm
1-1/4" 32mm
7/8" 1-5/16" 34mm
1-3/8" 35mm
1" 1-1/2" 38 mm
1-5/8" 41mm
1-1/8" 1-11/16" 43mm
1-3/4" 45mm
1-1/4" 1-7/8" 48mm
1-3/8" 2" 51mm
1-1/2" 2-1/4" 57mm
1-5/8" 2-1/2" 64mm
1-3/4" 2-5/8" 67mm
2-3/4" 70mm
1-7/8" 2-15/16" 75mm
3" 76mm
2" 3-1/8" 80mm
3-1/4" 83mm
2-1/4" 3-1/2" 89mm
3-3/4" 95mm
2-1/2" 3-7/8" 99mm
4" 102mm
2-3/4" 4-1/4" 108mm
4-1/2" 114mm
3" 4-5/8" 118mm
3-1/4" 5" 127mm
3-1/2" 5-3/8" 137mm
5-1/2" 140mm
3-3/4" 5-3/4" 146mm
6" 152mm
6-1/2" 165mm
7" 178mm





Dimensions for those making their own CO2 tire filling system:



Roof Rack: Barricade J116279
https://www.extremeterrain.com/barricade-removable-hard-top-roof-basket-0717-jk.html


Warn Zeon 10-S Winch

Parts diagram from Montana Jacks:

How to measure wheels:

Ham Radio:

Icom ID-5100A
Antenna Mount: Comet CP-5NMO; Max power 75W VHF, 50W UHF
Antenna: Diamond NR770HNMO;
3.0dB(2m); 5.5dB(70cm); Max power 200W
1/2 wavelength 2m radialless
2 x 5/8 wavelength 70cm phase element radialless
APRS APO3 automatic switch (turns on when voltage >= 13 volts, turns off 10 minutes after voltage drops) Hook for microphone: https://www.gigaparts.com/lido-products-lm-1201.html?utm_term=sku-zli-lm-1201 Lido Products LM-1201


Mahindra parts list: https://parts.mahindrausa.com/dealerview/illustration.aspx

Washer: Maytag Neptune MAH5500BWQ Dryer: Maytag Neptune _________

No comments: